Powis Parker FastBack Model 11 Návod k obsluze stáhnout pdf (Strana 10)

MODEL 11 KEY OPERATOR’ S MANUAL 9

IV REMOVING A JAMMED BINDERSTRIP

™

WARNING: Internal parts can be extremely hot! Do not attempt to open

the machine unless you are a trained Key Operator or qualified service

technician. Follow all precautions. Always turn the Power Switch to the “Off”

position and unplug the machine before opening. Always wear the Heat

Protective Glove (included in your Accessory Pack) when removing a

jammed Binderstrip

™

1. Turn the Power Switch to “Off”, unplug the machine and let the

machine cool for approximately 15 to 20 minutes.

2. Remove the Cooling Rack from the top of the machine.

3. Open the machine by pushing the eraser end of a pencil through the

hole in the lower right corner of the machine (figures 2 and 3) until

the machine cover pops open slightly.

4. Gently push the cover up until it stops in the upright position.

5. If you cannot easily reach the jammed Binderstrip

™

with the Wire Tongs,

lift the blue metal bookrest (figure 4). Always wear the Heat Protective

Glove.

6. Remove the Binderstrip

™

using the Wire Tongs supplied in your Accessory Pack.

7. After removing the jammed Binderstrip

™

, press the blue metal book

rest back into its original position, until it clicks and locks into place.

8. Close the machine by pressing down on both sides of the cover until

the latch clicks and locks in position.

DIAGRAMA/ SCHÉMA/ FIGURE 2

DIAGRAMA/ SCHÉMA/ FIGURE 3

DIAGRAMA/ SCHÉMA/ FIGURE 4

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 22 23

Žádné komentáře

Powis Parker FastBack Model 11 Návod k obsluze Strana 10